General description

This product is supplied as a lyophilized fibrous powder in a 1 gram package size. Bioburden and endotoxin levels are tested – this product is not considered sterile.This collagen product is naturally cross-linked yielding a robust material for applications which require structure and strength. This product can be readily prepared into such forms as tissue scaffolds, foams, sponges, suspensions, coatings, putties, films and sheets but does not form hydrogels. Using typical cross-linking methods, this material can be tuned for optimal in vivo resorption. This collagen product is ideal for tissue engineering applications and uses with inorganic and biomaterials. The product is provided in user-friendly packaging for use and storage. Avoid extended exposure to ambient environment since this material is hygroscopic.

Other Notes

Simultaneously vacuum filter 12 samples for rapid analysis of retentate or filtrate. Numbered positions on the filter plate assure accurate sample tracking. Sealing stoppers maintain vacuum on unused sample cups. Accessory extension barrels increase sample volumes from 15 to 50 mL. r> r>Applications r>General Filtration of 15 to 50 mL Samples, Preparation for Scintillation Counting r> r>XX2702550 1225 Sampling Manifold r> r>Replacement Parts r>YY2214257 Hand Knob r>5162 Top Plate r>XX2702509 Filter O-ring, silicone r>5163 Support Plate r>XX2702510 Support Screen, 25 mm, polypropylene r>XX11000PP Ball Valve, glass-filled polypropylene r>XX2504755 Tubing, 1/4 in. x 23 in., latex r> r>Accessories r>XX2702552 Chamber O-rings and Plug Set r>XX2702555 Sample Cup Extension Barrel r>XX6200006P Filter Forceps, blunt end, stainless steel r>XX7100004 Tubing 3/16 in. I.D. x 140 cm, silicone

Preparation Note

Type I bovine collagen, insoluble lyophilized fibrous powder, is extracted from bovine flexor tendon with the raw material sourced from closed/controlled herds of animals. This product is very difficult to dissolve, and after following the below protocol you will end up with a viscous solution.Note: The following procedure is based on solubilization of 1 gram of collagen in 100 ml to initially prepare a 10 mg/ml collagen suspension. Smaller quantities and volumes may be used but the same ratios of collagen and solutions should be used. 1. Weigh out 1 gram of collagen fibrous powder. 2. Reconstitute 1 gram of collagen with 50 ml of cold purified water (50% of the final volume). 3. Stir the collagen with the water continuously mixing for a minimum of 15 minutes until the collagen is fully wetted and the suspension appears to be a semi-solution. 4. Add 50 ml of cold 0.02 M HCl to the collagen mixture and stir for a minimum of 10 minutes. This will yield a collagen concentration of 10 mg/ml with the suspension continuing to appear as a semi-solution. 5. Measure the pH - the mixture should have a pH of 2 to 3. 6. Using Waring stick blender or equivalent, homogenize the collagen mixture for a minimum of 15 minute at a high speed ensuring that the collagen is fully homogenized. Ensure that the temperature of mixture does exceed 24°C. Upon completion, there should be no visual solids in the viscous suspension. Air bubbles with be prevalent. 7. To remove air bubbles, stir the solution on a stir plate and pull a vacuum on the suspension. This will remove the air bubbles. 8. At this point if a collagen concentration of less than 10 mg/ml is desired, the collagen can be diluted with 0.01 M HCl.